26
GB
APPROVED POWER TOOL ATTACHMENTS
The following Emak attachments may be mounted
to the basic power tool:
EH 25
Hedge trimmer (adjustable)
(1) (2)
EH 50
Hedge trimmer (adjustable)
(1) (2)
EP 100
Pole pruner
(2)
EP 120
Pole pruner
(2)
(1)
Safety boom (A, Fig.9A) must be assembled
under the loop handle.
(2)
Not approved for use with bike handle units
(DS 3500 T - BC 350 T)
.
5. STARTING
FUELING
WARNING: Gasoline is an extremely
flammable fuel. Use extreme caution when
handling gasoline or fuel mix. Do not smoke
or bring any fire or flame near the fuel or the
unit.
·
To reduce the risk of fire and burn injury,
handle fuel with care. It is highly flammable.
·
Mix and store fuel in a container approved for
gasoline.
·
Mix fuel outdoors where there are no sparks or
flames.
·
Select bare ground, stop engine, and allow to
cool before refueling.
·
Loosen fuel cap slowly to release pressure and
to keep fuel from escaping around the cap.
·
Tighten fuel cap securely after refueling. Unit
vibration can cause an improperly tightened
fuel cap to loosen or come off and spill
quantities of fuel.
·
Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting
engine.
·
Never attempt to burn off spilled fuel under
any circumstances.
·
Do not smoke while handling fuel or while
operating the unit.
·
Store fuel in a cool, dry, well ventilated place.
must point toward the gearbox) onto the bike
handle (N) so that the holes (P) line up.
- Insert screw (G) and tighten down firmly.
WARNING: Make sure that all
components are connected properly and all
screws tightened.
PREPARING TO WORK
HARNESS (4S, Fig. 1)
Correct adjustment of the harness permits the
brush cutter to be properly balanced and at an
appropriate height from the ground (Fig. 10).
- Put on the single harness.
- Hook the brush cutter to the harness using the
hook (A, Fig. 10).
- Position the hook (19, Fig. 1) to obtain the best
brush cutter balance.
- Position the buckle to obtain the correct brush
cutter height.
CORRECT ADJUSTMENT OF THE HARNESS
DS 3500 T - BC 350 T models
1. Put on the double harness (4T, Fig.1).
2. Fasten the waist buckle (A, Fig.12) and adjust
by tightening the top belt strap (B) until
comfortable.
3. Fasten the chest buckle (C).
4. Adjust the shoulders by tightening the two
straps (D, Fig.13) until comfortable. With this
type of harness, the weight of the machine can
be distributed between shoulders and waist
according to the preference of the operator.
5. Adjust the chest strap (E, Fig.12).
6. Hook the brushcutter to the harness with the
snap (A, Fig.10).
7. Adjust the carrying height by shortening or
lengthening the belt straps (H-L, Fig.14). The
correct distance between the belt and the
snap can be measured as in Fig.10. This
adjustment will also help to distribute the
weight of the brushcutter so that it stays
comfortably balanced during operation.
WARNING!
– When using wood-cutting
blades (22-60-80 teeth) a double harness with
quick-release mechanism
must be worn.
