Eela Audio EA816 manual
8
OPERATION:
Connect the audio output of the unit to the input and the audio input to the cleanfeed output of your
mixing desk or other system that you will be using. A normal telephone handset can be connected to
the RJ10 connector on the back.
Connect the antenna provided by simply screwing on the SMA connector. In case you will be using the
unit in a metal housing like a 19” rack the use of an antenna with cable is recommended. A metal
housing acts as a Faraday cage resulting in a bad r.f. reception. An antenna with a cable placed
outside of the rack will solve this problem.
Switch on the unit by connecting the power adapter delivered with the unit. (or use a suitable 12V 1A
power source). After e few second the unit will be ready to use.
If no SIM card is placed or a SIM card with another PIN code as “0000” a message will be displayed:
Place a suitable SIM card in the slot and switch off and on the unit by removing and reconnect the
power to restart the unit.
Key-in a telephone number and press the
ON “Connect” button to make a call.
You can store up to 10 telephone numbers in non volatile memory by pressing “ * “ followed by one
of the numeric keys:
To recall one of the stored telephone numbers press “ # “ followed by one of the numeric keys.
INCOMMING CALL
An incoming call is indicated by a blinking green
ON “Connect” button and the telephone number
of the caller will be displayed. Answer the call by pressing this button.
In auto answer mode the display will indicate “connect”.
To end a call press the
OFF “Disconnect” button.
LOCAL OPERATION
The audio is either routed to the main input and output or to the headset. You can connect the audio
I/O to the headset by pressing the bottom right
headset button. This way you can make a call
independently or communicate to a caller off-air. If active a yellow LED underneath the button will
light and the loudspeaker icon in the display will change into a headphone icon.
