Edwards A311-01-985, Инструкция по эксплуатации

Страница: 30 / 50

A311-03-880 Issue A
Page 22 © Edwards Limited 2014. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
Figure 7 - Coupling dimensions
3.8 Motor electrical connections (HV8000 pumps with motors only)

Ensure that the electrical installation of the HV8000 pump conforms with your local and national safety
requirements. It must be connected to a suitably rated fused and protected electrical supply and a suitable
earth (ground) point.
3.8.1 Introduction
Use the procedures in the following sections to connect the electrical supply to the motor.
Refer to the motor rating plate and terminal box for details of the electrical supply voltage and frequency, of the
full load current rating, and of the connection diagram for the motor fitted to your HV8000 pump.
If you have provided your own motor, connect in accordance with the instructions which have been provided with
the motor.
However, it is recommended that you read Section 3.8.2 to 3.9 inclusive and take appropriate note of any relevant
information.
WARNING
Obey the safety instructions given below when you make the electrical connections. If you do not,
you can cause injury to people.
Dimension d1 is to suit motor shaft
Note: The 2.5 mm dimension is between teeth not hubs.