© 2013 UTC Fire & Security. All rights reserved.
1 / 2
P/N 270493 • REV 06 • REB 18JAN13
Control-Display Module Installation Sheet
Description
Control-display modules provide additional operator interface
capability for the life safety system. They can be mounted on
any local rail module, except the 3-CPU3 and 3-ANNCPU3.
Inserts are provided for labeling switches and LEDs.
This document provides installation instructions for the control-
display modules listed below.
Model
Description
3-
24R
Twenty-
four red LEDs
3-24Y
Twenty-
four yellow LEDs
3-24G
Twenty-four
green LEDs
3-
12RY
Twelve red-over-
yellow pairs of LEDs
3-12SG
Twelve LED
-
switches with green LEDs
3-
12SR
Twelve LED
-
switches with red LEDs
3-12SY
Twelve LED
-
switches with yellow LEDs
3-12/S1GY
Twelve LED
-switches with green-over-
yellow LEDs
3-
12/S1RY
Twelve LED
-switches with red-over-
yellow LEDs
3-12/S2Y
Twelve LED
-switches with yellow-over-
yellow LEDs
3-
6/3S1G2Y
Six groups of three LED
-
switches with green LEDs
(top switch), and yellow LEDs (middle and bottom
switch)
3-
6/3S1GYR
Six groups
of three LED
-
switches with green LEDs
(top switch), yellow LEDs (middle switch), and red
LEDs (bottom switch)
3-
4/3SGYWR
Four groups of three LED
-
switches with green LEDs
(top switch), yellow-over-
white LEDs (middle
switch), and red LEDs (bottom switch)
Installation
Cautions
•
This product contains components that are sensitive to
electrostatic discharge (ESD). Handle with care.
•
Installing this product with power applied will damage the
equipment. Power down the panel before installing.
To install a control-display module:
1. Fill out the label insert. Slip it between the overlay and the
circuit board. See Figure 1.
2. Insert the left side of the control-display module into the
door frame then push in on the right side until it snaps into
place.
3.
Connect the ribbon cable (P/N 250186) to the rail module
with the red edge of the cable pointed up.
Figure 1: Installation