Edwards & Co oscar g3, Инструкция по эксплуатации

Страница: 10 / 16

Bumper bar installation and removal
To
install
the bumper bar, insert the rods on each end of the bar
into the bumper bar retaining bracket until you hear a
CLICK!
To
remove
the bar, press the release buttons located on the
underside of the bumper bar retaining bracket (as pictured below).
1. Locate the canopy hood hinge (as pictured).
2. Using a phillips screwdriver, remove the two screws on one
of the canopy hood hinges.
3. Pull out the hood frame tubes from it’s housing in the hinge.
4. Remove the fabric canopy.
5. Thread the new fabric canopy through the hood tubes (the front
of the canopy threads through the slightly bent tube).
6. Re-insert tubing and screw back into place.
Note - use this step to install your limited edition canopy hoods.
Canopy installation and removal