971
LONER
®
high performance
Temperature Controlled
Soldering Station
SPECIFICATIONS
• 120V, 50/60Hz, 70W, 2.5 lbs. (1.13 kg.)
• COMPLIES WITH DOD-STD-2000-1B, MIL-STD-
2000A and ESD SPEC. DOD-STD 1868, DOD-
HDBK-263
• TEMP. RANGE: 400°F - 800°F (205°C - 427°C)
• TEMP. REGULATION: ±6°F (±3°C)
• TIP TO GROUND LEAKAGE: < 2MV
• TIP TO GROUND RESISTANCE: < 2 OHMS
• UL LISTED
m a d e
in
U S A
Static Safe
1. Turn on power
and set Temperature
Control Knob to 400°F.
2. Using a clean and well tinned Tip,
apply a small amount of solder on the
Tip, just enough to form a bead on top
of the Tip.
3. Place the center of the thermocouple
wire of the
SDS100
on top of the bead.
4. Again, apply a small amount of solder
on the center of the thermo-couple
wire, just enough to embed the center.
5. Adjust LO-Temp. Calibration Pot so the
Meter will read 400°F.
6. Set Temperature Control Knob to 800°F.
7. Adjust Hi-Temp. Calibration Pot so the
Meter will read 800°F.
AIR MOVEMENT WILL AFFECT THE TEMPERATURE READING.
WORK IN AN AREA WHERE THIS IS MINIMAL.
MS412
Temperature
Calibration System
SDS100
FX635
TEMPERATURE CALIBRATION
TIP CARE
1. Set desired temperature. Blinking
Lamp means Tool is regulating.
2. TIN the Tip. (apply solder)
3. Do not rub, bend or reshape the Tip.
4. Always clean the Tip by wiping it
against the saturated sponge and
always RE-TIN.
Temp. Control
Hi/Lo Temp. Calibration Pot
Temp. Regulation
Indicator
Sponge Holder
Power Switch
Loosen RCS71
Collar by turning
counter-clockwise
and pull the Tip
straight out.
Direct Tip/Heater
Contact
PD528
Tool Pod
WARNING: DO NOT HIT OR TAP THE
TOOL. HEATER ELEMENT WILL BREAK!!!
To replace Pod,
press Release Tab
and slide out Pod.
