Assembly of this unit is done by fitting the rivets of the beams and braces into the slots of the posts.
The unit is assembled one level at a time. Each level is assembled with two beams (a) and two braces (b) connected to
the posts (c) and one wire shelf (d).
These units should be placed on a level surface. Failure to do so can result in a possible safety hazard.
This unit should be securely anchored to a wall or floor with suitable fasteners, which are not included.
Do not use this unit for anything other than the manufacture’s intended purpose.
Do not stand on any part of the unit, or use it as a ladder.
Use care when working with metal parts.
Evenly distribute the weight on each level and always keep the heavier loads on the bottom.
Safety & Assembly Instructions
STEP 1 …
check the orientation of the components
Check that each post is in the proper orientation. The post should
be positioned so that the tapered end of the hole is pointing down-
ward.
Check that the flat surface of the beam and brace ledge is facing in
the desired orientation.
STEP 2 …
assemble bottom level
Assemble one brace to two lower posts skipping one hole from the
bottom of each post.
Place the rivets into the posts, and tap lightly to seat the rivets.
Repeat this with the other two lower posts and braces.
Assemble the beams into the two post and brace assemblies.
Place a wire deck on the ledge of the assembled beams and braces
with the flat side facing upwards.
STEP 3 …
assemble next level
Connect another two braces and two beams to the posts for the next
level.
Check that each beam and brace is spaced equally.
Place a wire deck on the ledge of the assembled beams and braces
STEP 4 …
connect posts with couplers
Position the couplers on the top edge of each bottom post.
Tap the couplers down to the mid-point of the coupler.
Position another post into the top half of the coupler and tap down
until the two posts connect fully into the coupler.
STEP 5 …
assemble the remaining levels
Connect additional braces and beams to the posts for each level.
Check that each beam and brace is level and properly spaced.
Place a wire deck on the ledge of the assembled beams and braces
for each level.
STEP 6 …
final assembly and check
Check each beam and brace connection to be sure that the rivets
are properly seated.
Place and fasten the post caps to the top of each post.
F: post cap
E: coupler
C: post
C: post
ALTERNATE HORIZONTAL CONFIGURATION ...
Shelf can be split into two units and used side by side. Cou-
plings are not required.
Beams and braces should be positioned in the top and bottom
two post holes of each section for stability.
vertical or
horizontal
configuration
Should you have any comments, missing parts, or problems with assembly of this unit
please contact our Quality Service and Manufacturing facility at
773-475-3137 or [email protected]
To obtain replacement parts, please provide the following information :
- Model Number - Part Number & Description - Location Purchased - Date Purchased
Edsal Manufacturing Company
4400 South Packers Avenue
Chicago, IL 60609
www.edsal.com
REV 2.2A
Made in the USA
patents pending