Take one (1) 38 3/8” bottom back post (top end has a
half slot hole), and (1) 36 top right back post (top has
slot holes, bottom has rivets) and create a coupled back
post. Take one (1) 18” brace (
shelf ledge up)
, and one
(1) 35” front post and attach the rivets of the brace to
the top two (2) holes of the front post. Take the coupled
back post and attach the opposite rivets to the holes so
the
brace is level.
Tap brace down to seat. Attach the
bottom 18” brace to the front post
skipping one (1)
hole
from the bottom,
and the opposite end level to
the coupled back post. Tap brace down to seat. Take
one (1) drawer mount and insert the rivets one (1) slot
hole below the 18” top brace on both ends, and tap to
seat. Repeat steps for the opposite end assembly.
Assembly Instructions for URWB
Assembly Instructions for URWB
Assembly Instructions for URWB
-
-
-
3
3
3
Take Four (4) 36” beams with the
shelf ledge facing
up
, and attach two (2) even with the end assembly's
bottom braces, and two (2) even with the braces at the
top. Install one (1) back 36”
Flat
beam with the
bend
facing down
, to the top holes of the top back posts.
Take the two (2) support extensions, and Install one (1)
36”
Flat
beam with the
bend facing down
, to the front
holes of the top support extensions to create the top
shelf assembly. Take the support extension’s rivets of
the assembly, and Install the top shelf assembly even
with the rivets of the 36” back
Flat
beam of the unit.
Place the two (2) halves of the peg board to the inside of the
back post of the work bench. Align the holes of the peg
board to holes on the back post. Fasten using the nuts and
bolts provided. Take two (2) drawer slides, one (1) silver,
and one (1) black 31”
Flat
drawer braces. With the
bend
facing down
, insert the rivets of the
black
brace into the slot
and half slot holes located on the
back
end of the drawer
slides. Insert the laminated shelf, and install the
silver
front
drawer brace to the front of the drawer slides. Install the
drawer assembly to the drawer mounts slides of the unit.
Install the handle to the front drawer brace, and add the
laminate shelves to the top shelf, bottom shelf, and work
surface to finalize the assembly of the workbench. Op-
tional anchor hardware is supplied with this unit so the
unit can be fastened to a wall if necessary.
Step
1
Step
2
Step
3
Step
4
Post are directional.
The slot must point
down.
Shelf Ledge Up
Skip Hole From Bottom
Tap Lightly
Two (2) Piece
Peg Board
(Bolts at the post)
Top
Right
Back
Post
(36”)
Right Side
Drawer Mount
38 3/8”
Bottom Post
18” Brace
36” Top
Right Back Post
35” Front Post
Bottom
Back
Post
(38 3/8’”)
36” Beams
(Ledge Up)
36”
Flat
Beam
(Bend Down)
Top Support
Extensions
Peg Board
Fastens at
These Points
(opposite side also)
36”
Flat
Beam
(Bend Down)
Laminate
Shelf
Right Side
Drawer Slide
Silver Flat Drawer Brace
(front)
(Bend Down)
Black Flat Drawer Brace
(rear)
(Bend Down)