3-24
Section 3
— Installing The Editor
Other Machine Assignments
Other machines are listed below the AUX and BLK assignment sections. If
the protocol for a particular machine is built into your software, it is
identified. If a machine protocol is not built into your software, NONE
appears next to it.
For example, if (as in Figure 3-13) you have the protocol for a GVG Model
100 Video Switcher, but not a Character Generator, GVG100 appears next
to VIDSW and NONE appears next to CHRGN. Assignment choices are
limited to port number, baud rate, and EVEN or ODD parity. The
assignment procedure is:
1. Use
[
↑
]
and
[
↓
]
to highlight the desired machine and then press
[ENTER]
. The system prompts:
PORT # = ?
2. Enter the port number the selected machine is connected to and press
[ENTER]
. The port number you selected appears on the display next to
the selected machine and the system prompts:
0 = 38.4 1 = 9600 BAUD =
3. Press, as applicable, either
[Ø]
for 38.4K baud or
[1]
for 19.6K baud and
then press
[ENTER]
. The baud rate you selected appears on the display
on the same line as the selected machine and the system prompts:
0 = NONE 1 = ODD 2 = EVEN PARITY =
4. Press, as applicable, either
[Ø], [1]
, or
[2]
and then press
[ENTER]
. The
EVEN/ODD parity selected appears on the display on the same line as
the selected machine.
5. Repeat Steps 1 - 4 for the remaining machines.
NOTE:
Press
[SHIFT][RESET]
(all keyboards) to re-establish communication
between the Edit System and all peripheral devices.
