Power supply (module)
Mains input connections L=Live, N=neutral, GND= ground/earth
DC power link to amplifier socket
Power supply (External)
Power lead
Power supply
DC power cord
Specification
Rated Power Output 15Watts x 2
Output impedance
4Ω or 8Ω speakers
Frequency
Response
50Hz~50kHz ± 3dB
Signal-to-Noise
Ratio
≥ 60dB (MIC)
≥ 70dB (AUX)
≥ 65dB (MP3)
Input Sensitivity
5mV (MIC)
50mV (MP3)
600mV (AUX)
Input Impedance
10K (MIC)
47K (MP3)
47K (AUX)
47K (PC)
Supply Voltage
DC 24V
Power Consumption 34W
Dimension
85mm(W) x 72mm(D) x 85mm(H)
Weight
229g
Installation
The amplifier is designed for use inside buildings and is best installed near to the location of it's input devices
such as PC or DVD player etc. In a classroom this would normally be close or next to the interactive
whiteboard at a height that is easily accessible by the teacher to control the volume and connect and
disconnect devices
The following locations should be avoided if possible
•
Areas with excessive moisture or damp
•
Places that expose the faceplate to direct sunlight
•
Locations over radiators or other heating equipment
Back Box
The backbox design with sliding cable entry makes installation very easy, simply fix the back box to the wall
and place the cables in position, no need to thread cables or connectors through holes, though knock-outs
are provided if needed.
The lower half of the back box sliding plate can be “snapped off” or left whole if cables are fed from the rear
of the backbox
Page
3
of
5
Copyright © 2008 Edis Trading (HK) Limited
Protected by European Community Design Rights
