10
III
Getting Started
This section provides an introduction to the web-based configuration utility,
and covers the following topics:
Powering on the device
Connecting to the network
Power over Ethernet (PoE) considerations
Starting the web-based configuration utility
III-1
Power
III-1-1
Connecting to Power
Power down and disconnect the power cord before servicing or wiring a switch.
Do not disconnect modules or cabling unless the power is first switched off.
The device only supports the voltage outlined in the type plate. Do not use any
other power components except those specifically designated for the switch.
Disconnect the power cord before installation or cable wiring.
The switch is powered by the AC 100-240 V 50/60Hz internal high-performance
power supply. It is recommended to connect the switch with a single-phase
three-wire power source with a neutral outlet, or a multifunctional computer
professional source.
Connect the AC power connector on the back panel of the switch to the
external power source with the included power cord, and check the power LED
is on.
Figure 7 - Rear View AC Power Socket
