MU 22N
17
5 STORAGE AND RESTARTING
5.01 STORAGE
In case of long periods of inactivity, proceed as follows:
5.01.01 ELECTRIC MOTOR
- Clean all the internal electrical parts (rotor, stator, cooling circuit) with compressed air
DO NOT USE CONDUCTIVE OR FLAMMABLE LIQUIDS TO CLEAN INTERNAL
ELECTRICAL PARTS
- To clean the outside of the machine, if necessary, use a cloth dampened in soapy
water and then dry thoroughly
- Check the following are in good condition:
• insulation
• power cable
• switches
• plug
• brushes and manifold
• clean the stator, rotor, cooling circuit and fan with compressed air
5.01.02 CYLINDER AND HYDRAULIC COMPONENTS
Before performing these operations, see the relative instructions in Chap. 3
·
Check the hydraulic oil and top up or, if necessary, replace.
·
Clean the magnetic cap and check the membrane.
·
Check for any oil leaks.
·
Tighten the screws.
Store the tool in a dry place that can only be accessed by authorised staff.
5.02 RESTARTING
Before performing these operations, see the relative instructions in Chap. 3
- Check the oil tank is full and top up if necessary
- Remove any traces of oil remaining after topping up or applied to protect metal parts
from the grip and other parts that can be gripped.
ELECTRIC MOTOR
- Ensure that the power cable, the plug and the machine body have not been damaged.
- Start the machine a few times and make sure no operating faults occur.
ELIMINATE ANY FAULTS BEFORE STARTING WORK.