SPECIFICATIONS
:
Power output:
RMS 5W 4+10W+15W(THD=10%)
Signal to noise ratio: 80dBA
Input port: 3.5mm Stereo Line-in
Input impedance: 10Kohm
Adjust mode: Front key , remote
Bass unit: Magnetically shielded,5 inch paper cone,4ohm
Mid-range unit: Magnetically shielded,3 inch paper cone,4ohm
Tweeter unit : Magnetically shielded,
ohm
Input power: Refer to the rear panel
Subwoofer dimensions:
155(W) 235(H) 339(D)mm
Satellite dimensions
110(W) 180(H) 70(D)mm
Center dimensions:
251(W) 90(H) 64(D)mm
Weight: About 7.8kg
3/4 inch ,8
No sound from any speakers:
Is there power to the system?
Ensure that your subwoofer is plugged securely into a working AC wall outlet and power indicator is on.
Ensure that the power switch on the subwoofer is on.
Are you receiving an Audio Signal?
Connect your speakers to an alternate audio source, such as portable CD player or walkman to determine
that your speakers are working.
Popping/Buzzing/Humming from the System:
Are your cable connections secure?
Ensure the input cable is snugly inserted into the input socket on the rear of the subwoofer.
Try plugging the system into a different AC wall outlet.
Note: A slight low level of hum or vibration is normal as the subwoofer contains a transformer.
Distorted, Little, or No Sound in One or all Satellite Speakers:
Are your Soundcard Settings Properly Configured?
Ensure your computer has the latest soundcard drivers from the manufacturer.
Most computers contain a standard two-channel soundcard and will not require any adjustments to the
speaker configuration.
Adjust your computer`s internal volume settings for left-right balance.
Ensure that there are nicks, cuts, kinks in your input cable.
Jiggle the cables at the subwoofer input sockets whilst playing music through the system to detect a break in
the audio signal.
Adjust the master volume control whilst playing music through the system to determine whether the level of
distortion changes.
Determine if the problem persists in the same channel or moves to the opposite channel when the left and right
speaker connections and reversed.
No sound or weak bass from the subwoofer:
Is the bass volume too low?
Adjust your computer`s internal treble and bass volume settings to mid-level.
TROUBLESHOOTING
3
Playing the audio device
Plug the power cord into the AC outlet and turn on the power switch, the system enter the status of adjusting
volume and start playing , the power indicator and VOL
indicator is on, press the
and
key, the volume
can be increased or decreased (or turned off); press the
MODE
function key, the
C
indicator is ON and
VOL
indicator is off, the system enter fine-tuning status of center, at the same time ,press the
and
key ,the center volume can be adjusted imperceptibly ; Press the
MODE
key again, the
F
indicator is on,
the
C
indicator is off ,the system enter the status of front fine-tuning ,press
and
key ,the front
volume can be adjusted imperceptibly; Press the
MODE
key again, the
R
indicator is on, the F
indicator is off ,the system enter the status of surround fine-tuning ,press
and
key ,the surround
volume can be adjusted imperceptibly; Press the
MODE
key again, the
SW
indicator is on ,the R
indicator is off ,the system enter the status of bass fine-tuning ,press
and
key ,the bass volume can be
adjusted imperceptibly; when you press the
MODE
key again,the system return the status of volume ,the
system will circle according to the above order.
