If at least one of the timers is on, the Recorder will switch from standby mode to record mode at the specified
time, which is indicated by flashes of the red LED.
Password Protection of Records
Use configuration file (CONFIG_CARD24.INI) to set password protection of records. Password is set in the
corresponding section [Security]. Enter a 8-digit password in the field 'Password'.
After memory card has been installed into the Recorder, the digits of the password in configuration file will be
automatically replaced with '*' symbols to avoid obtaining the password by unauthorized persons. To cancel
password protection, enter 8 zeros in the field Password. To change the previously set password, instead of
the symbols ******** simply enter a new digital password in the Password field.
Setting Time and Date
Time and date can be set via configuration file [Service]. Time and date need to be set correctly for proper
timer operation and system time accounting.
In order to set new time, specify new time and date values in the corresponding fields of the configuration file
and allow time update by setting the SysUpdate option value as 1, and insert memory card into the Recorder.
The Recorder reads configuration file each time a new memory card is inserted into the slot. In this case, the
red LED makes a short flash, stating the configuration file has been read successfully.
After the Recorder sets system time, the SysUpdate option in the configuration file is automatically rewritten
to '0'. It is done so in order there is no subsequent change in system time during subsequent installation and
removal of the card, if this is not required by the user.
Changing Settings with Configuration File (CONFIG_CARD24.INI).
All the Recorder's settings are made using the CONFIG_CARD24.INI configuration file. This is a text
configuration file, which is to be written by the user onto memory card.
Any word processor on your PC can be used to open the CONFIG_CARD24.INI file, make changes to it, save.
Then insert memory card into the Recorder, and the file will be read by the Recorder, which will be indicated
by the flash of the red LED indicator for several seconds, and the settings specified in the file will be accepted
by the Recorder.
The lines of the configuration file should be edited only in the corresponding fields; adding new comments to
the file or deleting existing lines is not permissible, and may lead to incorrect reading of the file.
If you accidentally delete a configuration file, a sample of it will be automatically rewritten onto memory card.
Attention
, before removing microSD card, the record must not be in one of the operation modes, and the LED
indication should be off. Failure to do so may result in an incorrect recording completion and loss of all
information on the memory card.