EDI EDV206-104-4D-N1-STACK, Быстрое руководство

Страница: 3 / 4

Display Configuration
−Timer Mode−
Preset display
1. Press the SETUP button on the remote to pause the display.
2. Press the EDIT button to enter EDIT mode.
3. Using the number buttons on the remote, input the desired preset in minutes-seconds
format (MM:SS). Press the ENTER button when complete.
Start Timing
 To TIME UP, press the Up arrow button above the TIMER1 label on the remote
 To TIME DOWN, press the Down arrow button below the TIMER1 label on the remote
 When the display reaches “00:00”, the stack light and audible alarm will activate for three
seconds.
Note : Display colons will turn on when the display begins timing.
Active or disable Alarm
1. Press the DEL button when the display is paused.
2. The least significant digit will flash on and off with the current setting for the alarm.
Configure the alarm by inputting one of the values below and pressing
ENTER on the
remote.
0 to Disable Alarm
1 to Enable Alarm
3. There is also a physical input (push button or switch) that needs to be set. Follow the
instructions below based on the version of the display you received.
I. If the display received has three different color LEDs (left display shown on first
page), there is a push button on the opposite side of the power input.
While the display is power on, press the button.
-If the value in the least significant digit is a 1 , the alarm is activated .
-If the value in the least significant digit is a 0 , the alarm is disabled .
II.
Reset the display
 Press the button labeled RESET on the remote to set the display back to the previous
preset value
Note

If the colons are on and the display is not timing up or down, the display is in
Clock Mode. Press the Timer Up or Timer Down button to enter Timer Mode.