23
Perform docking at idle or no wake speeds. Always try to come into wind or current, whichever is
stronger. This allows you to use the natural forces on your boat to act as a natural brake. The
skipper is free to use the boat’s power to control speed and direction.
The approach to the dock should be at roughly a 45° angle, when possible. This approach angle
allows the captain to bring the bow close to the dock, and then to use reverse, while turning the
wheel toward the dock, to bring the boat to a safe, controlled stop.
Never approach a dock on plane. Even after reducing engine speed, the wake will push the boat
uncontrollably into the dock.
9.7 After Operation
Refill the fuel tank and engine oil if it is a two-cycle engine. A full fuel tank is less subject to
condensation and therefore, less fuel problems. If you will be leaving the boat for an extended
period, use a good fuel stabilizer. Each engine manufacturer makes their own and proper use will
avoid many fuel related and lay-up problems. Remember; always follow the manufacturer’s
recommendation.
If the boat is to be left in the water, make sure it is secure and free to properly accommodate
any tide.
Turn off all electronics and leave the battery switches in the off position. Remember, the bilge
pump will operate properly even with the battery switches turned off. On a comforting note, your
EdgeWater 245CX is fully self-bailing and unsinkable. Proper precautions, however, are always
prudent.
Check to make sure that the through hull drains are not obstructed by coolers or other
equipment, or clogged with debris such as bottle caps and trash.
9.8 Trailering Your Boat
Note: If you have doubts or questions about your tow vehicle or towing, contact your
dealer.
Before going on the highway, make sure your tow vehicle and trailer meet the local
regulations for trailers and towing in your state.
Before leaving the driveway, make sure the lights on the trailer are operating properly. If
necessary, get a second person to make sure of the operation.
At least once a season, check and repair/replace the trailer wheel bearings.
The trailer should be adequately sized for your boat. Allow about 10% above
the maximum boat weight for trailer capacity.
Make sure your vehicle is properly equipped to handle the load. This
includes engine, hitch, frame, brakes, transmission cooler, and vehicle
capacity.
Securely attached the boat trailer to the vehicle hitch, hook the safety
chains and cross them under the hitch and check the lights to ensure they are
Tow
vehicle
Trailer
Bottom View of
Crossed Trailer
Chains
Содержание 245CX
