Edgewater Networks 225 Express, Руководство пользователя

Страница: 23 / 49

5 5
5 5
5
Electrical System
EdgeWater 225 Express 23
5.2 Accessor 5.2 Accessor
5.2 Accessor 5.2 Accessor
5.2 Accessory Panel Switches y Panel Switches
y Panel Switches y Panel Switches
y Panel Switches
Your EdgeWater 225 EX is equipped with panel breakers. One switch is for the running/anchor lights, one
for the optional livewell, one for an optional washdown system, one to activate the bilge pump manually
and the other three are left free for the owner to use for accessories. A wiring diagram is included with this
manual to assist you in troubleshooting the boat’s electrical system. Please note that the accessory
circuits are each protected by a 20 amp breaker. Check the requirement of any device you install and
change the breaker to the required ampacity if necessary.
The boat will have a battery selector switch which provides isolation for
each battery and also provides the ability to have a back-up in case of a
dead or weak battery. When in port and running accessories such as
entertainment equipment or pumps, the selector switch should be set on
“1” or “2”. When leaving the boat unattended, the selector switch should
be in the “OFF” position.
**NO **NO
**NO **NO
**NOTE** TE**
TE** TE**
TE** Current is supplied to the automatic float switch and the bilge pump even when the battery
selector switch is in the “OFF” position.
Avoid running the selector in the “both” position, as the weak battery will drain the charged battery,
leaving you with two weak batteries. Instead, start the engine using the charged battery. Once the
engine is running, turn the battery switch to the “both” position to charge both batteries.
5.3 Electrical System Maintenance 5.3 Electrical System Maintenance
5.3 Electrical System Maintenance 5.3 Electrical System Maintenance 5.3 Electrical System Maintenance
At the beginning and end of each season the exposed electrical components of the switch
panel should be sprayed with a non-conductive rust/corrosion inhibiting spray. Light bulb
connections and running light connections should be covered with a non-water soluble lubricant.
Care must be taken not to get grease on the glass portion of the lights as it will cause them to overheat and
burn out. Inspect all wiring for breaks, loose terminals and sound insulation. Replace worn or deteriorated
components. Check the electrolyte level in the batteries regularly and fill with distilled water, as necessary.
DO NO DO NO
DO NO DO NO DO NOT O
T O
T O T O T OVERFILL.
VERFILL.
VERFILL. VERFILL. VERFILL.
“2” Position “OFF” Position