Edgetech 3200-XS, Руководство пользователя

Страница: 35 / 74

Locating the Deck Unit
3-3
3.4 Locating the Deck Unit
The Deck Unit should be located and set up in a dry, sheltered area that is protected from
weather and water spray and where the temperature is consistently between 0°C and 40°C
(32°F and 104°F). Avoid areas of direct sunlight, especially in tropical environments, as
heat buildup could occur and viewing the LCD monitor and status indicators could be
difficult. The location should also enable direct communications with the deck crew that is
handling the tow vehicle. Secure the Deck Unit it in place, using tie-downs if necessary,
near the required AC power source. If you are mounting the 3200-XS Topside Processor
and the Power Amplifier in a 19-inch rack other than the supplied rack mount enclosure,
ensure that there is ample room behind the rack for connecting the cables. Support the
components inside the rack using appropriate mounting brackets and secure the front
panels using standard 19-inch rack front panel mounting hardware.
3.5 Deck Unit Controls and Indicators
The Deck Unit includes controls and indicators on the front and back as shown in
Figure 3-1 and Figure 3-2. Several test points are also provided for voltage measurements.
The 3200-XS Topside Processor controls, along with a DVD R/W drive and a 3.5-inch are
located behind an access panel as shown in Figure 3-3 on page 3-6.
The Deck Unit controls and indicators are the following:
POWER SUPPLY: Rocker switch. Turns on the power supply in the
3200-XS Topside Processor. This switch can be
left in the on position at all times.
SYSTEM POWER: Push button toggle switch. Turns the 3200-XS
Topside Processor on.
POWER: Rocker switch. Turns the Power Amplifier on. A
red indicator above the switch lights when on.
RESET: Momentary push button switch. Resets the
3200-XS Topside Processor.
HARD DISK: Red indicator. Indicates when a hard drive on
the 3200-XS Topside Processor is active.
SYSTEM: Green indicator. Illuminated when the 3200-XS
Topside Processor is on.
POWER AMP OUT TX1: Red indicator. Flashes when Channel 1 of the
Power Amplifier transmits.