5
Installing the Door Handle
1
2
3
4
5
To install the door handle:
Open the door and carefully pull the door gasket (#1) around the area
where the handle (#4) is to be installed.
Insert each Phillips head screw (#3) and flat washer (#2) through the
gasket side of the door until the screw pass through the door.
Align the handle with the screws and tighten using a Phillips head
screwdriver until the handle is flush against the door frame.
CAUTION: Do not over-tighten the screws as this may cause damage to
the handle or to the stainless steel door.
Carefully press the door gasket into its original position.
Installing and Removing the Shelves
To prevent damaging the door gasket, make sure to open the door all the
way before pulling the shelves out of their track.
To install the shelves:
1. Open the door completely.
2. Slide the shelf on the shelf track and slowly push back until it stops.
3. Push down on the front of the shelf to allow the back of the shelf to lift
over the plastic post. (Imagine a seesaw movement.) Continue to push
the shelf back until both notches pass through the plastic posts on each
side of the shelf track.
4. Continue to push the shelf back.
To remove the shelves:
1. Open the door completely.
2. If necessary, make sure you remove all the contents sitting on the
shelf.
3. Pull the shelf forward until the notch aligns with the plastic post on each
side of the shelf track.
4. Lift the shelf until both notches pass through the posts.
5. Continue to pull the shelf forward until it is completely removed from
the inner compartment.
