EdgeStar Built-in Beverage Cooler
4
Installation Clearance Requirements
When installing the beverage cooler under a counter, follow the
recommended spacing dimensions shown.
• To ensure proper service access and ventilation, allow at least 2/5”
clearance at the back, 1/5” at top and 1/5” at sides. The installation
should allow the unit to be pulled forward for servicing, if necessary.
• The beverage cooler should be installed on a firm and level surface that
will be able to support the entire weight of a fully loaded unit. It is
important for the beverage cooler to be level in order to work properly. If
needed, you can adjust the height of the beverage cooler by rotating the
feet. See the “Leveling the Beverage cooler” section.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded
in accordance with National Electrical Code and local codes and
ordinances is required.
2/5
”
1/5
”
1/5
”
Door Hinge
Back of unit
Top View
1/5
”
Side View
Important Notes:
• Choose a location that has
ambient temperatures above
50°F and below 95°F.
Operation outside these
temperatures may result in
lowered efficiency or cause
other adverse effects.
• This unit MUST be installed
in an area protected from the
elements, e.g., wind, rain,
water spray or drips.
• The beverage cooler should
not be located next to ovens,
grills or other high heat
sources.
• Do not kink or pinch the
power supply cord between
the beverage cooler and wall
or cabinet.
