EdgeStar BIDW1802, Руководство по обслуживанию

Страница: 29 / 39

28
Troubleshooting
Factory Diagnostic Mode
To enter the factory diagnostic mode:
1. Turn the dishwasher off and make sure all LEDs are off.
2. Disconnect the power
3. Reapply power with the door open and press and hold both the Rinse and
Start/Cancel button within 60 seconds. Close the door and the display will show
each board type code and F* (* = 0,1,2) for 1 second. Then the dishwasher will
run the factory diagnostic mode as shown below.
No. Component Display Note
01
Wash Pump
Impeller
Turbidity
Turns on water inlet and impellor then after
10 seconds turn off the fan. The flow meter
will control the water inlet to let in 3L water.
This step has turbidity detection function the
SSD will the turbidity value.
02 Heating Element
04 / Water
Temperature
Turns on the wash pump then after 10
seconds, the heater will turn on. The unit will
beep one time when the temperature has
risen 3~5 degrees for the first time. The
dishwasher will stop when the temperature
has arrived at 135°F (57°C). Press
"start/cancel" to enter the next step.
03
High Wash
Pump Dispenser
03
Turns on wash pump for 8 seconds after a 2
second delay, then turns on the dispenser
for 45 seconds.
04 Pause 02 Pauses for 30 seconds.
05 Drain Pump 01 Turns on the drain pump for 30 seconds.
06 End
Board Type
Code and F*
Beeps one time. The SSD will show the
board type code and F* (* = 0,1,2). Restart
the dishwasher to enter standby mode.