7
Warning: Use two or more people to move and install the Beverage Cooler. Failure to do so
can result in back or other injury. Carefully remove the packaging materials. Remove any
shipping tape and glue from your Beverage Cooler before use. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your Beverage Cooler.
Important: Do not remove any safety, warning, or product information labels from your
Beverage Cooler.
Installing the Beverage Cooler
The Beverage Cooler should be installed in accordance with local electrical code requirements.
The Beverage Cooler should also be placed in a location that is strong enough to support its
total weight, keeping in mind that it will weigh substantially more when fully loaded than when
empty.
Before you plug the Beverage Cooler into a power supply, be sure to let it stand
upright for at least 24 hours to allow the
compressor’s oils to settle.
Unpacking the Beverage Cooler
Types of Installation
This Beverage Cooler has been designed for free-standing or built-in installation. In each case,
there must be adequate ventilation and access for service.
Free-standing Installation:
A free-standing installation will allow you to install the Beverage Cooler in almost any place
you desire. You must follow the stated instructions for electrical requirements and leveling
the Beverage Cooler.
Built-in Installation:
A recessed installation will allow you to install the wine cooler under a counter or in a
kitchen cabinet as long as the required clearance space around the wine cooler is
provided. It is necessary to allow adequate ventilation space around the unit, including at
the back of the unit. The following additional items must be observed:
1. Place the Beverage Cooler in front of the installation location. Adjust the feet and
place the unit flat on the floor or on a platform depending on your installation
requirements.
2. If the electrical outlet for the Beverage Cooler is behind the cabinet, plug in the
Beverage Cooler.
3. Push the Beverage Cooler into position.
Tip: Gather the model
and serial number
from the product label
and write them down
before installing the
Beverage Cooler.
Warning: DO NOT install the Beverage Cooler behind a closed cabinet door.
