Edge Technologies Minuteman 320 SE, Руководство по эксплуатации

Страница: 54 / 222

MINUTEMAN
320
47
REV 13.1:2020
4.9 Change Axial Swiss Mode to Chucker Mode
Caution bar feeder must be in emergency stop prior to axial
shifting bar feeder.
Caution all attaching components must be installed and tightened
prior to production.
Caution only trained personnel should be converting the lathe and
bar feeder to Swiss or chucker option.
1. With the bar feed in manual operation be sure there are no active faults
2. Place lathe headstock in Swiss mode Z positive over travel position
3. Place bar feed into Emergency stop condition (press bar feed E-Stop button)
4. Place lathe into Emergency stop condition (press lathe E-stop button)
5. Disconnect bar feed synchronous rod and telescoping nose from lathe head stock.
6. While in Swiss mode remove the guide bushing assembly per lathe manufacture
instructions. It may be required to reset the emergency stops to complete the removal of
the guide bushing. Use extreme caution.
7. From the underside of bar feeder stand cabinets, remove 4 axial track locking bolts from
both stands
8. Rotate axial shift lever to move bar feed.
9. Push bar feed forward to the chucker position.
10. Reinstall 4 locking bolts into axial track plates.
11. Verify headstock is in the chucker zone.
12. Reattach telescoping nose and sync rod to head stock.
13. Reset Emergency stop condition previously set.
14. Verify the emergency stop safety interlocks on the synch assembly are properly
positioned.
15. The parameter values below must be checked and changed as necessary.
a. Max end of bar
b. Facing distance
c. MAVD opening position (if used)
16. Verify proper operation of head stock movement and bar feed response.