Edge Products Juice Attitude CTS2, Руководство пользователя

Страница: 65 / 68

65 65
Trouble Shooting Guide
Appendix
SYMPTOM POSSIBLE CAUSE SOLUTION
Display beeps for two seconds The unit is too hot due to direct sunlight Once cooled, the display will turn on
No display when the key is “on” The screen has not yet been activated Touch the screen or start the vehicle
Fusion drivers will not install correctly The drivers were not successfully installed Manually install the drivers
Camera picture is frozen Bad connections Double check your fuse and connections
Display beeps quickly Possible device malfunction Update the device using Fusion software
Unit will not power on after vehicle is
started or after screen or buttons are
pressed
Typically this issue is caused by a blown
OBDii/Cigarette Lighter Fuse
Replace fuse and test unit again
On Star®:
Unable to receive monthly On Star®
e-mail reports
Having the display plugged into your
OBDii port may disturb On Star while
gathering information for their reports.
Unfortunately, there is no real solution
for this issue. You could try and call
On Star to see when they gather their re-
ports, and unplug your device during that
time. This may or may not work for you.
Vehicle does not start after programming The calibration may not have written
properly
Select “ Return to Stock” from the pro-
gramming menu. Then program back
to stock. Next, start the vehicle. If the
problem continues, contact customer
support.
Error 16 when programming There was a communication error Try to program the level again
Evolution Programming Errors:
1. Your device gest stuck on the “Upload-
ing Boatloader” screen
2. An error is displayed: “ERROR-we
could not upload the bootloader to the
vehicle...”
3. If you are constantly asked to make
sure your key is on.
4. Error displayed after you device shows
blank gauges and says that it is loading.
The error will be displayed as “ Cannot
communicate with vehicle, ensure the
key is in the on position...”
Sometimes programming can be disrupted
by installed aftermarket devices that are
tapped into the trucks communication lines
(J1850). These may include but are not
limited to aftermarket radios, chime boxes,
remote starters, etc.
Also, any power consuming devices should
not be plugged into the cigarette adapter
during the programming process.
Fluctuations in power may disrupt the
programming process.
The following solutions are good first
steps to getting around these program-
ming errors. If these steps do not solve
your problem, please contact customer
support.
FUSES: (CAUTION: Always turn the
key off while unplugging fuses).
1. Remove fuses connecting radio, radio
amplifier, satellite radio, remote starter,
or any other aftermarket device you have
installed on your vehicle.
POWER :
1. Close all doors during programming.
2. Do not operate electrical accessories
(radio, windows, wipers, etc.)
3. Remove any devices plugged into the
cigarette lighter or any other auxilary
power port.