Edge EZ User Manual
Edge Products
11
Attach and Install the 3 Position Switch
1.
Attach the 3-position switch cable with the green connector to the mating green
connector on the harness (
see Figure 1A and 1B
) and pass it through or around
the rubber boot in the driver side firewall behind the battery. (
see Figure 2
)
After routing the switch under the dash, mount the switch to the lower dash
panel at the left of the steering column. (
Note:
The cable and switch may also
be routed around the outside door pillar and placed on the dash.
)
FIGURE #2
2.
Using a 1/4 inch drill, carefully drill a hole through the lower plastic dash panel.
Insert the switch through the hole and secure in order: the tab ring, internal star
washer and then tightening the nut.
Caution:
Make sure the location you select
to drill the hole does not drill into wires or other critical components.
Boost Elbow Installation (Optional)
The installation of the brass elbow permits turbo boost pressures of greater than 20
psi without the wastegate opening. The
Edge EZ Module
will operate equally well
with or without this installed. (The turbo is located on the passenger side of the
engine compartment.)
1.
Using the 5/16” socket, loosen the two clamps securing the air induction hose to
the air filter housing and the turbo inlet. Remove the hose and set it aside.
Pass the power switch
cable through the boot
on the driver side firewall
to access the dash
board inside the cab
.
