Edge-Core ECS4120-28F, Справочное руководство, Страница: 776 / 938

Chapter 26
| CFM Commands
Defining CFM Structures
– 776 –
4.
Enter a static list of MEPs assigned to other devices within the same
maintenance association using the
mep crosscheck mpid command. This
allows CFM to automatically verify the functionality of these remote end points
by cross-checking the static list configured on this device against information
learned through continuity check messages.
5.
Enable CFM globally on the switch with the ethernet cfm enable command.
6.
Enable CFM on the local MEPs with the ethernet cfm port-enable command.
7.
Enable continuity check operations with the ethernet cfm cc enable command.
8.
Enable cross-check operations with the ethernet cfm mep crosscheck
command.
Other configuration changes may be required for your particular environment,
such as adjusting the interval at which continuity check messages are sent
(
page 793 ), or setting the start-up delay for the cross-check operation ( page 799 ).
You can also enable SNMP traps for events discovered by continuity check
messages (
page 795 ) or cross-check messages ( page 799 ).
Defining CFM Structures
ethernet cfm ais level
This command configures the maintenance level at which Alarm Indication Signal
(AIS) information will be sent within the specified MA. Use the
no form restore the
default setting.
Syntax
ethernet cfm ais level level-id md domain-name ma ma-name
no ethernet cfm ais level md domain-name ma ma-name
level-id – Maintenance level at which AIS information will be sent.
(Range: 0-7)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric
characters)
Default Setting
Level 0
Command Mode
Global Configuration
Command Usage
The configured AIS level must be higher than the maintenance level of the domain
containing the specified MA.