Edge-Core ECS4110-28T, Руководство по управлению, Страница: 1062 / 1514

C
HAPTER
31
| Congestion Control Commands
Automatic Traffic Control Commands
– 1062 –
C
OMMAND
U
SAGE
After the apply timer expires, a control action may be triggered as specified
by the auto-traffic-control action command and a trap message sent as
specified by the snmp-server enable port-traps atc broadcast-control-apply
command or snmp-server enable port-traps atc multicast-control-apply
command.
E
XAMPLE
This example sets the apply timer to 200 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
auto-traffic-control
release-timer
This command sets the time at which to release the control response after
ingress traffic has fallen beneath the lower threshold. Use the no form to
restore the default setting.
S
YNTAX
auto-traffic-control { broadcast | multicast }
release-timer seconds
no auto-traffic-control { broadcast | multicast } release-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The time at which to release the control response after
ingress traffic has fallen beneath the lower threshold.
(Range: 1-900 seconds)
D
EFAULT
S
ETTING
900 seconds
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
This command sets the delay after which the control response can be
terminated. The auto-traffic-control auto-control-release command must
be used to enable or disable the automatic release of a control response of
rate-limiting. To re-enable a port which has been shut down by automatic
traffic control, you must manually re-enable the port using the auto-traffic-
control control-release command.
E
XAMPLE
This example sets the release timer to 800 seconds for all ports.
Console(config)#auto-traffic-control broadcast release-timer 800
Console(config)#