Edge-Core ECS4110-28T, Руководство по управлению, Страница: 1063 / 1514

C
HAPTER
31
| Congestion Control Commands
Automatic Traffic Control Commands
– 1063 –
auto-traffic-control
This command enables automatic traffic control for broadcast or multicast
storms. Use the no form to disable this feature.
S
YNTAX
[ no ] auto-traffic-control { broadcast | multicast }
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
Automatic storm control can be enabled for either broadcast or
multicast traffic. It cannot be enabled for both of these traffic types at
the same time.
◆
Automatic storm control is a software level control function. Traffic
storms can also be controlled at the hardware level using the
switchport packet-rate command. However, only one of these control
types can be applied to a port. Enabling automatic storm control on a
port will disable hardware-level storm control on that port.
E
XAMPLE
This example enables automatic storm control for broadcast traffic on port
1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast
Console(config-if)#
auto-traffic-control
action
This command sets the control action to limit ingress traffic or shut down
the offending port. Use the no form to restore the default setting.
S
YNTAX
auto-traffic-control { broadcast | multicast } action
{ rate-control | shutdown }
no auto-traffic-control { broadcast | multicast } action
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
rate-control - If a control response is triggered, the rate of ingress
traffic is limited based on the threshold configured by the auto-
traffic-control alarm-clear-threshold command.