Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 742 / 1116

Chapter 27
| IP Interface Commands
IPv4 Interface
– 742 –
Basic IPv4 Configuration This section describes commands used to configure IP addresses for VLAN
interfaces on the switch.
ip address
This command sets the IPv4 address for the currently selected VLAN interface. Use
the
no form to remove an IP address.
Syntax
[ no ] ip address { ip-address netmask [ secondary ] | dhcp }
ip-address - IP address
netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets. The network
mask can use either the traditional format xxx.xxx.xxx.xxx or classless
format within the range /5 to /32. For example the subnet 255.255.224.0
would be /19.
secondary - Specifies a secondary IP address.
dhcp - Obtains IP address from DHCP.
Default Setting
DHCP
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
If this router is directly connected to end node devices (or connected to end
nodes via shared media) that will be assigned to a specific subnet, then you
must create a router interface for each VLAN that will support routing. The
router interface consists of an IP address and subnet mask. This interface
address defines both the network number to which the router interface is
attached and the router’s host number on that network. In other words, a
router interface address defines the network and subnetwork numbers of the
Table 152: Basic IP Configuration Commands
Command Function Mode
ip address Sets the IP address for the current interface IC
ip default-gateway Defines the default gateway through which this switch can
reach other subnetworks GC
show ip interface Displays the IP settings for this device PE
show ip route Displays specified entries in the routing table PE
show ip traffic Displays statistics for IP, ICMP, UDP, TCP and ARP protocols PE
traceroute Shows the route packets take to the specified host PE
ping Sends ICMP echo request packets to another node on the
network NE, PE