Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 492 / 1116

Chapter 18
| VLAN Commands
Configuring L2CP Tunneling
– 492 –
Configuring L2CP Tunneling
This section describes the commands used to configure Layer 2 Protocol Tunneling
(L2PT).
l2protocol-tunnel
custom-pdu
This command configures the PDU format and pattern used for custom PDUs.
Syntax
l2protocol-tunnel custom-pdu index destination-mac { bpdu protocol-id
eth2 ethertype snap oui protocol-id }
index – PDU identifier. (Range: 1-16)
destination-mac – Destination MAC address. (Format: xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxx; for example, 01-23-45-00-00-00)
bpdu – IEEE 802.3 BPDU with logical link control (LLC) data communication
protocol layer 42-42-03.
protocol-id – Range: 0-ffff hexadecimal
eth2 – Ethernet II packets.
ethertype – A two-octet field in an Ethernet frame. It is used to indicate
which protocol is encapsulated in the payload of an Ethernet Frame.
(Range: 600-ffff hexadecimal)
snap – The Subnetwork Access Protocol is an extension of the IEEE 802.2
Logical Link Control (LLC) udrf to distinguish many more protocols of the
higher layer.
oui – A 24-bit number that uniquely identifies a vendor, manufacturer, or
other organization. (Range: xxxxxx hexadecimal)
Default Setting
None
Command Mode
Global Configuration
Table 96: L2 Protocol Tunnel Commands
Command Function Mode
l2protocol-tunnel custom-
pdu Configures the PDU format and pattern used for custom
PDUs GC
l2protocol-tunnel tunnel-
dmac Configures the destination address for Layer 2 Protocol
Tunneling GC
switchport
l2protocol-tunnel Enables Layer 2 Protocol Tunneling for the specified
protocol IC
show l2protocol-tunnel Shows settings for Layer 2 Protocol Tunneling PE