Edgarsson GSM-VAC4+LITE, Руководство по установке

Страница: 35 / 39

GSM-VAC4+LITE INSTALLER’S MANUAL
OUTPUTS REMOTE CONTROL
You can use outputs remote control on two different ways:
⇒
calling the GSM-VAC4+ LITE and use DTMF commands
⇒
send the SMS command and get back the SMS with outputs status
1.26 OUTPUTS REMOTE CONTROL BY SMS COMMAND
Command ; ORCX=1;
Sending this command to the GSM-VAC4+ LITE the output X is going ON.
X = output 1-4
Command ;ORCX=0 ;
Sending this command to the GSM-VAC4+ LITE the output X is going OFF.
X = output 1-4
When you want to get the return message with the Output status you must press + before the
command. For example:
Command ;+ORCX=1;
The return message will be:
ORCX=(ON)
1.27 OUTPUTS REMOTE CONTROL BY DTMF COMMAND
After the short beep press the DTMF command. Response with 1 beep means that the output is
active (ON) and response with 3 beep means that the output is in inactive (OFF) mode.
11 Output 1 ON (bi-stable) or ON for mono-stable
12
Check the output 1 state (1 beep=ON, 3 beeps=OFF)
10
Output 1 OFF (bi-stable) or ON for mono-stable
20 Output 2 OFF (bi-stable) or ON for mono-stable
21 Output 2 ON (bi-stable)
Use 12, DTMF command to verify the output state. With DTMF command “00” you may put all
outputs OFF and with command ”01” all outputs ON in the same time.
Page 3