Starting Operation of the bark - stripper
In this version, the device may only be operated in agriculture and forestry by
instructed persons. The relevant regulations for the prevention of accidents
are to be observed. Apply the bark stripper to the trunk surface at running saw
engine only at full revolution, and lead the bark stripper over the trunk
continuously and without pressure. Should the stripper cut too deep or even
chip, the knives are to be set back by around 0.2 mm. If the cutting depth is
too short, the knives are to be set forward by around 0.2 mm. The required
knife adjustment is based on the type of wood to be peeled and must be newly
adjusted as the case arises. It is to be observed that the hard metal pins on
the knife disc (0211) always stand right to the knife edge. All 4 knives must
have the same adjustment and the same measure to the hard metal pins. Dull
knives can be reground by hand at normal grinding wheels. The edge angle is
40°.
Instructions for Use
Before every application, the trunks to be peeled are to be checked. Nails,
sticky sand and other foreign material must be removed before planing, as
otherwise the peeling knives will be damaged. On actuation, the machine is to
be safely supported and held tight, at which the peeling barrel must stand free.
Apply the peeling device to the plane trunk surface only with the saw engine
running at full revolution. For the use of the saw, read the operating
instructions of the saw manufacturer.
