READ ALL INSTRUCTIONS BEFORE USING THE HEATER
1.
We recommend keeping the packaging for off-season storage and for any transportation needs.
2.
Find a level and unobstructed location to place the unpackaged heater.
3.
Do not plug in or run any appliances on the same circuit that the heater is on.
4.
Plug the power cord directly into an unused, grounded outlet.
Used to turn power to the unit on and off.
Used to turn the heater on and off. This will only work if the master power switch (shown above) is on.
Used to increase the desired temperature.
Used to decrease the desired temperature.
Used to switch between LOW and HIGH modes.
a. LOW MODE: In low mode, the heater runs on a lower wattage in order to use less electricity.
Running the heater in low mode can sometimes be more beneficial in smaller rooms where
less heat is necessary.
b. HIGH MODE: In high mode, the heater consumes more wattage but also produces more
heat. High mode is recommended for larger rooms that are harder to keep warm.
IMPORTANT: To turn the heater off, press the “POWER” button; the fan will continue to run until
all of the heat has been expelled. This could take up to 3 minutes in some cases.
DO NOT UNPLUG WHILE RUNNING.
WARNING
IMPROPER USE OF THIS HEATER COULD RESULT IN RISK OF FIRE, ELECTRIC SHOCK,
AND INJURY TO PERSONS
WARNING
ANY REQUIRED SERVICE, OTHER THAN FILTER MAINTENANCE, SHOULD BE PERFORMED
ONLY BY AN AUTHORIzED SERVICE REPRESENTATIVE. ANY OTHER REPAIRS, ATTEMPTED BY ANYONE
OTHER THAN AN AUTHORIzED SERVICE REPRESENTATIVE, WILL VOID THE WARRANTY.
FOR AUTHORIzED SERVICE, CALL 1-800-839-0966 OR VISIT WWW.EDENPURESERVICE.COM.
WARNING
RISK OF ELECTRICAL SHOCK. DO NOT OPEN.
NO USER-SERVICEABLE PARTS INSIDE.
1.
READ ALL SAFETY INSTRUCTIONS BEFORE USING THE HEATER
2. This heater’s grill is hot when in use. To avoid burns do not let bare skin touch hot surfaces. Keep combustible ma-
terials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front, sides
and rear of the heater.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is
left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug, or after it has been dropped or damaged in any manner.
In such cases, return the heater to an authorized service facility for inspection/repair.
6. Do not use the heater outdoors or on construction sites.
7. The heater is not intended for use in bathrooms, laundry areas and similar indoor locations, areas with standing
water, a shower or swimming pool. Never place the heater where it may fall into a bathtub or other water con-
tainer.
8. Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Arrange
the cord away from traffic areas and where it will be tripped over.
9.
To disconnect the heater, turn the unit off, then remove the plug from the outlet once the fan has stopped running.
10. Manual restart maybe required if power to this unit is interrupted.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric
shock or fire, or damage the heater.
12. To prevent a possible fire, do not block, or place anything in the front or rear of the heater.
13. When performing filter maintenance, do not force the filter to dry using alternative methods. Doing so could damage
the filter.
14.
A heater has hot and arcing or sparking parts inside.
Do not use in areas where gasoline, paint, or flammable
liquids are used or stored.
15. This product contains a button battery. If swallowed, it could cause severe injury or death in just 2 hours. Seek
medical attention immediately.
16. Use this heater only as described in the manual. Any other use not recommended by the manufacturer may cause
fire, electric shock or injury to persons and may void the warranty.
17. Do not plug the heater into any other cord-connected device such as a power strip, surge protector, multiple outlet
adapter, grounding adapter or outlet-type air fresheners.
Plug into a 3-prong 120v 15amp or higher grounded
circuit receptacle only.
Do not plug the heater into a loose-fitting or broken receptacle. This heater is for use on
120 volts. The cord has a plug as shown at “A” in the Figure below. An adapter shown at “C” is available for con-
necting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should
not be used if a three-slot grounded receptacle is available.
18.
SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
PARTS AND FEATURES
WASHABLE LIFETIME FILTER SYSTEM
TrustedCOMFORT heaters come with a washable lifetime filter that is easy to clean.
IMPORTANT INFORMATION:
If you have allergies and/or are sensitive to dust, you will want to use
this filter. When choosing to use the filter, it must be cleaned as often as necessary; a clogged filter will
prevent the heater from working to its fullest capacity. If the heater is used in an extremely dirty or
dusty area, the filter must be cleaned more frequently to keep it from clogging.
To clean the filter:
1. Release the filter. (See pictures)
2. Run warm tap-water over the filter in the opposite direction of air flow, until the water runs clear.
The filter might excrete some filtered residue so be cautious not to drip on any stainable surfaces
such as carpeting. You can also soak the filter in water mixed with a small amount of mild dish
soap. Don’t forget to dry the filter after it has been rinsed.
3. Shake the filter over a sink until excess water is removed and allow it to dry completely before
reinstalling. DO NOT force the filter to dry using any alternative methods.
4. Reinstall the filter to the rear of the unit by positioning the filter back in place and securing
the filter back into the locked position.
PERFORMANCE RECOMMENDATIONS
To assure maximum performance, please follow the recommendations below:
1.
For best results, do not locate the heater in an area with a high rate of air movement, as the
warm air may be removed from the area you are intending to heat.
2.
Try placing the heater near a warmer inside wall and direct the output toward a cooler outside
wall. The cooler outside wall will tend to draw the heat toward itself, which will encourage more
efficient heating.
3.
Do not place the heater next to a cold air return, as this will draw the heat away from the area
to be heated and prevent efficient heating. Experiment with the placement of the heater to see
what works best for you.
4.
To ensure maximum efficiency, a 40% (minimum) relative humidity should be maintained in the
heated environment.
5.
The heaters are designed to operate for maximum efficiency in a room temperature range from
40° to 90° F.
6.
Try lowering your central heating system to a lower temperature and placing the heater in the
area you spend the majority of your time. Now set the heater to your desired comfort level.
After all, there is no point in heating multiple rooms when they are not in use.
7.
When heating larger areas, place the heater in a central location. If a ceiling fan is nearby, try
using it at the same time to help distribute the heat evenly.
NOT RECOMMENDED FOR
Basements • Garages • Sheds • Rooms with Vaulted Ceilings • Construction Sites
Outdoor Areas • Any Non-Insulated Area
Retail Partner Enterprises, LLC.
7800 Whipple Ave NW
North Canton, OH 44720
FAQs
GROUNDING
PIN
1. Q: How do I get the filter off?
A: See “To Clean the Filter” section of this manual.
2. Q: How do I get the remote cover off?
A: See diagram below.
3. Q: Where do I find the serial number?
A: On the back of the heater, there is a large, black, rectangular sticker. Toward the middle of the
sticker is the serial number.
4. Q: What does the red light that comes on when I plug the unit in mean?
A: The light simply indicates that the unit is plugged in, the master power switch is in the on position
and that it can be turned on for use at any time.
Model :
$
Rating : AC
120V~60Hz
Wattage : 1500W/1600(0ºC)
Serial No. :
903G081400001
0
81
40
00
01
FAQs Continued on Back
2. With the tab
pushed toward the
right, slide the lip of
the battery tray
toward you.
1. Push the far
tab on bottom,
left-hand side of
the back of the
remote toward
the right.
1. Place your
fingers on the
bottom of the
filter and press
upward to
release the filter
from resting on
the two tabs.
2. With the filter
lifted off of the
tabs, pull it
toward you to
release it.
(A)
METAL SCREW
COVER OF GROUNDED
OUTLET BOX
(B)
(C)
(D)
GROUNDING
MEANS
GROUNDING
PIN
ADAPTER
When using electrical appliances, basic precautions should always be followed to
reduce the risk of fire, electric shock and injury to persons, including the following:
I-5242 BR11120R-1 11/3/14 12:02 PM Page 2
