1 4 | H I F I D E L I T Y F O R L O W F R E Q U E N C Y
E D E N
| W T P 9 0 0 |
R E A R PA N E L F E A T U R E S - 9
H I F I D E L I T Y F O R L O W F R E Q U E N C Y
| 1 5
E D E N
| W T P 9 0 0 |
R E A R PA N E L F E A T U R E S - 9
World Tour Pro 900 Rear Panel Features.
SPEAKER OUTPUTS: The Eden Illuminated Output System used on World Tour Pro amplifiers has been designed by Eden to more easily
allow players to make the right choices with their rig selection. Because the sockets are illuminated, it allows you to simply select the mode
that suits your cabinets ensuring you get the best performance with the equipment you own.
Each mode selected switches between bridge / bi-amp and represents the correct cabinet impedance that should be used
with the associated socket, Green indicates 4ohm compatibility, Amber indicates 8ohm compatibility and red indicates that the
socket should not be used.
Bridge Series: In addition to standard modes the World Tour Pro 900 is able to run in Bridge Series Mode. When engaged the amplifier can
be used in bridged mode with 2 - 4ohm cabinets.
1. Speaker Output 1: Depending on selected mode, connect the correct impedance cabinet here using a Speakon speaker lead here.
2. Speaker Output 2: Depending on selected mode, connect the correct impedance cabinet here using a Speakon speaker lead here.
3. Amp Left Speaker 2 Output: Depending on selected mode, connect the correct impedance cabinet here using a Speakon speaker lead
here.
4. Amp Right Speaker 2 Output: Depending on selected mode, connect the correct impedance cabinet here using a Speakon speaker lead
here.
5. Output Left: Take your left signal output (post loop) to external equipment here.
6. Output Right: Take your right signal output (post loop) to external equipment here.
7. Aux Input: Connect Auxiliary input signal from your MP3 player or other device using 3.5mm jack cable here.
8. Headphones: Connect your headphones using this 3.5mm output (the headphone volume is controlled by the Master Volume control on
the amplifier front panel).
9. Stereo Loop Return L: Return your left effect chain signal here.
10. Stereo Loop Return R: Return your right effect chain signal here.
11. Balance Control: Use this control to balance the level between the two amplifiers.
12. Stereo Loop Send L: Send your left effect chain signal out from here.
13. Stereo Loop Send R: Send your right effect chain signal out from here.
14. Bridge / Stereo mode: Switch between bridge mode and stereo mode here.
15. Cycle Mode: Cycle between available speaker output settings using this switch.
16. DI Volume: Adjust the output level of the DI Signal here.
17. Pre-Send: Take your signal from before the EQ stage here.
18. Pre-Return: Return your signal before the EQ stage here.
19. Ground Lift: Use this switch to lift ground on the DI output signal here.
20. Pre/Post Select: Select where the DI output signal is taken from here.
21. DI Out: Take XLR DI output signal from here.
22. Tuner Out: Take your signal for your tuner here.
23. Stomp: Connect optional Stompware Eden footpedal here to use footswitchable features on the amplifier.
24. X Over: Turn crossover circuit off or on using this switch.
25. X Over Control: Use this control to adjust the crossover point between each amplifier and the Left/Right line level outputs (Bi-Amp
mode only).