STEP ONE
2
Insert arches into arch keystone ensuring they terminate flush
to the internal connector. The tabs sticking out of the internal
connector should fit outside the arches. Ensure that the arches
are orientated properly as per illustration.
Fasten the arch system to the keystone by installing the
screws into the 2 pre-drilled holes provided.
Invert the arch system and install two screws from the bottom
of the keystone into the two pre-drilled flanges on either
side of the bottom of the insert. This will connect the bottom
of the arches to the insert.
Seal the bottom hole on the keystone by inserting the bottom
plate as provided.
Install the top cap on the arch keystone. Push down firmly
so the cap locks into position.
Repeat for other arch.
Insert arch rafters
(6)
into the holes on the arches until they
bottom out inside the arches. There are “locking tabs” located
at each end of these rafters that once inserted into the holes
will lock into place.
The Florence Arbor
Assemble the Arch System
1
2
3
5
www.edenarbors.com
7
1
5
4
2
6
7
3
4
