3.2.5 Opening magnetic detector
Installing the detector
The detector and magnet can be installed either by using double
sided (supplied) tape or screws.
Mount the magnet on the door (or window) and the detector (the part
containing the battery) on the jamb. The tip of the arrow on the
magnet should face the mark on the detector (see picture).
The space between the magnet and the detector should not exceed
10 mm. If necessary, the detector can be mounted upside down.
Open the battery cover by sliding it as shown in the drawing below.
The detector is secured by two screws on the back side.
The top screw is used to clip the detector while the bottom screw
goes through the bottom of the battery compartment, through the
pre-drilled hole.
Insert the 3V (CR2032) battery, the
+
side
up, and close the lid
When the door or window is opened, the red light turns on a few
moments.
LOW BATTERY:
When the detector battery needs to be changed,
the detector light is weak or does not light up.
3.3 Programming the phone dialer
3.3.1 Programming the alarm message
During the call, the alarm center sends a message must be first recorded. The message is 6 seconds
long.
To record the message:
-
Press
1234
(or your personal code) followed by
5
-
Stand 20-30 cm away from in the alarm center and record your message
-
If your message lasts less than 6 seconds, press any button to stop recording
3.3.2 Programming the phone numbers
You can save up to 4 phone numbers, which will be dialled one after the other, in the sequence in
which you saved them in case of alarm.
To save the phone numbers:
-
Press
1234
(or your personal code) followed by
7,
the red and yellow LEDs will flash
-
Enter the first phone number
-
Press
to confirm
-
Repeat the same procedure for the other numbers
If you do not enter any number, the alarm center will exit the programming mode automatically after
30 seconds.
7
A PROBLEM?
Do not hesitate to call us on our hotline on 0825 560 650.
Our technicians will be happy to help you to refine your installation.
