PERFORMER-PLUS CAMSHAFT/LIFTERS/LUBE KIT
Part #2152
MODEL: 400, 425, & 455 c.i.d. Oldsmobile V8, 1967 & later
(except Toronado)
INSTRUCTIONS
• PLEASE study these instructions carefully before installing your new camshaft. If you have any questions, do not hesitate to call our
Technical
Hotline at: 1-800-416-8628, Monday-Friday, Pacific Standard Time.
•
CAMSHAFT:
Edelbrock Performer-Plus camshafts are ground specifically for use with the corresponding Performer manifold #2151 on engines
operating from idle to 5500 rpm. The Performer Olds 455 manifold #2151 and Performer-Plus camshaft #2152 are designed to work as a team
to give you better driveability and performance. They are dyno-matched and street-proven. For best results, use the Edelbrock manifold/camshaft
package with the carburetor and headers we recommend.
NOTE:
Maximum performance is achieved when the Edelbrock Performer Olds 455 Power Package components are used with the following
equipment:
•
Performer Olds 455 manifold/camshaft/timing set/valve springs
•
Original Equipment Quadrajet carburetor (w/electric choke) or Edelbrock carburetor #1407 or #1411
•
1-3/4" headers
•
aftermarket/re-curved distributors
•
any combination of the above
•
IMPORTANT
: This instruction sheet provides general installation guidelines which can affect your warranty. Read it carefully. It is not our intent
to cover each detail of installation here; a step-by-step procedure manual would be far too lengthy. We want to caution you that installing a
camshaft is a complicated procedure that requires a good general knowledge of automotive engines. If you are not confident that you can complete
the camshaft installation successfully, we suggest you consider having it installed by an experienced mechanic.
CAUTION:
Improper installation will result in LOW MILEAGE, POOR PERFORMANCE, COSTLY REINSTALLATION, and ENGINE DAMAGE.
TO AVOID THESE PROBLEMS YOU MUST DO THE FOLLOWING:
•
Carefully study and understand all instructions.
•
Examine the camshaft for possible shipping damage (if damaged contact your dealer immediately).
• TOOLS AND EQUIPMENT
o
Use the following checklist for items needed.
o
box and open-end wrenches
o
socket set
o
distributor wrench
o
pliers (channel locks & hose clamp)
o
screw drivers (regular and phillips)
o
torque wrench
o
hammer
o
gasket scraper or putty knife
o
timing light
o
vacuum gauge
o
rags
o
water bucket
o
harmonic balancer puller
o
crank gear puller
•
HARDWARE & PARTS TO BUY
o
gaskets- OEM valley pan or equivalent
o
pipe plugs, if needed
o
Edelbrock Gasgacinch, #9300
o
RTV Silicone
o
chalk
o
paper and pencil
o
radiator coolant
o
teflon tape
o
Edelbrock Performer-Link True Rolling Timing Chain and Gear
Set #7813
o
New OEM Valve Springs or equivalent
PREPARATION CHECKLIST
©2009 Edelbrock Corp.
Brochure #63-2152
Part #2152
Rev. 2/09 - AJ/mc
Page 1
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and
may result in poor performance and engine or vehicle damage.
