Catalog #7075
Rev. 10/05 - RS/mc
©2005 Edelbrock Corporation
Brochure #63-0462
Page 2 of 2
INSTALLATION INSTRUCTIONS
1. Use only recommended intake gaskets set when installing this intake manifold. For ease of installation, we recommend Edelbrock
Manifold Bolt and Washer Kit, #8564.
2. Fully clean the cylinder head intake flanges and the engine block end seal surfaces.
3. Apply Edelbrock Gasgacinch sealant P/N 9300 to both cylinder head flanges and to the cylinder head side of the gaskets, allow to air
dry, and attach the intake gaskets.
4. Do not use cork or rubber end seals. Use RTV silicone sealer instead. Apply a ¼" high bead across each block end seal surface,
overlapping the intake gasket at the four corners. This method will eliminate end seal slippage.
5. Install the intake manifold and hold-down bolts. Torque all manifold bolts in two steps by the sequence shown to 25 ft/lbs
(See Fig. 2)
.
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 800-416-8628 • E-Mail: [email protected]
Figure 2 - 396-502 C.I.D. Chevrolet Bolt Torque Sequence
Torque Bolts To 25 ft./lbs.
Firing Order: 1-8-4-3-6-5-7-2
Turn Distributor Counter-Clockwise to Advance Ignition Timing
2
4
8
7
9
10
6
5
11
12
1
4
3
2
6
8
5
7
1
3
Figure 1 - Intake Manifold to Cylinder Head Port Match
