VT100 Vertical Crawler™
Document: UMAH000514.docm
Revision: A14
Created by: PJ
Date: 05 Dec 2019
3029669-A14
Source Location: C:\ePDM\ISLEng\products\ah-versatrax100\manuals\UMAH000514.docm
Page 18 of 28
User Ma
nual
Extension Brackets
To increase the operating pipe size range, 50 mm (2 in) or 75 mm (3 in) extensions brackets can be
installed onto the expansion linkages.
To install either size of extension brackets, do the following as shown below:
1. Fasten the correct sized track spacer to the spacer base using 4x M5 x 16 mm FHMS.
2. Attach the Microtrac
™ to the extension bracket using 4x M5 x 10 mm SHCS.
3. Attach the spacer base to the expansion linkages as detailed in the previous section.
4. Ensure there is enough cable fed through the chassis to plug in the track. Wires can generally be
secured to the long bushing on the driver linkage using a zip-tie.
5. Connect the track connector
–
make sure to align the mating pins correctly
.
6. Repeat this procedure for each of the other two tracks.
Bracket removal is the opposite of installation
