Versatrax 150™
Document: UMDW014058.docm
Revision: A03
Created by: KW
Date: 10 Oct 2019
3075415-A03
Source Location: C:\ePDM\ISLEng\products\dw-versatrax150mkii\manuals\UMDW014058.docm
Page 15 of 57
User Ma
nual
Vehicle and Tether
It is important that the tether be properly connected to the vehicle
– otherwise damage to the system may
result.
1.
Connect the vehicle end of tether to the back of the integrated harness block. Visually line up the
key in the connector before mating. Fully screw down and hand-tighten the locking collar.
2.
Secure the tow cable to the cable grip on the tether using the quick-link. Adjust the cable grip
position to maintain a small amount of slack tether regardless the direction the tether is pulled, as
illustrated below.
3.
Verify all device whips from the harness block to their respective components are securely
connected, and the whips are free from damage.
4.
Ensure any unused connectors are capped with dummy plugs to insulate and protect their
electrical contacts.
5. Tether connection to the parallel and inline vehicles are identical.
