SE-601 Series Electrocardiograph User Manual Entering Patient Information
- 32 -
Chapter 5 Entering Patient Information
5.1 Entering Patient Information Manually
1.
Configure the
Patient Information Setup
window. (Configurable)
2.
Select
Patient
on the main screen1 to open the
Patient Information
window.
NOTE:
The total number of supported characters may be fewer if special Latin characters
are entered.
5.2 Entering Patient Information by Using a Reader
(Configurable)
1.
Configure the bar code
For more detailed information about configuring the bar code, please contact the
manufacturer or the local distributor.
2.
Connect the bar code reader to USB socket 2 on the right panel of the electrocardiograph.
3.
When the main screen is displayed, scan the patient's bar code with the bar code reader, and
then the patient information will appear in the corresponding box.
NOTE:
Only the bar code reader recommended by the manufacturer can be used.
5.3 Entering Patient Information by Acquiring Orders
NOTE:
To use the order function, the ECG data management software (DMS) of the
manufacturer must be installed in the PC.
Operation procedures are as follows:
1.
Connect the electrocardiograph to the PC with Ethernet cable recommended by the
manufacturer.
2.
Log into the DMS.
3.
Set
Server IP
,
Local IP
,
Gateway
and
Subnet Mask
in the
Transmission Setup
window.
4.
Select
Order Acquired
function in
Setup-> Patient Info
.
5.
Open the
Patient Information
window.
6.
Enter the patient ID manually in the
ID
textbox or connect a bar code reader, press
Order
,
and then the matched order will be loaded from the DMS and the order information will be
displayed in the corresponding textboxes.
