6
EN
TORMENT
4WD
4WD
Solid Red and Green:
Battery voltage is
good (above 4V).
Solid Red: Battery
voltage is critically low
(below 4V). Replace
transmitter batteries.
TRANSMITTER CONTROLS
Battery Level Indicator
Power Switch
Power on or off the transmitter
Reverse Switch
Allows you to change the direction of
steering (ST) and throttle (TH) controls.
(The default setting for steering and
throttle is “NOR”)
Throttle Trigger
Controls power
to the motor for
forward or reverse
(See TH reverse
switch)
Stop
Reverse
(when TH reverse
switch on NOR)
Forward
(when TH reverse
switch on NOR)
Steering Wheel
Control steering. Right
and Left steering with
ST switch on NOR
(See Reverse Switch)
Steering Rate
Adjusts the amount the
front wheels move when
the steering wheel is
turned left or right
Throttle Dual Rate
Adjusts the maximum
amount throttle the
vehicle can be given
Adjusts the neutral
point of the electronic
speed control
Throttle Trim
Adjust to make the
vehicle drive straight
with no input at the
steering wheel
Steering Trim
INSTALLING THE VEHICLE BATTERY
1. Turn the battery door latch counter-clockwise to
release the battery door.
2. Remove the battery door from the vehicle.
3. Connect the battery to the Electronic Speed Control
(ESC) /Receiver unit connector within the battery
compartment.
4. Install the vehicle battery pack as shown.
5. Re-install the battery door.
6. Turn the battery door latch clockwise to secure
the door.
