4
EN
RUCKUS | TORMENT | K&N TORMENT
®
™
™
QUICK START
Please read the entire manual to gain a full understanding of the vehicle, fine-tuning the setup and performing maintenance.
1. Read the safety precautions found in this manual.
2. Charge a battery for the vehicle. Refer to the included
charging warnings and instructions for battery charging
information.
3. Install the AA batteries in the transmitter. Only use alkaline
or rechargeable batteries.
4. Install the fully charged battery in the vehicle.
5. Power ON the transmitter and then the vehicle. Wait 5 seconds for
the ESC to initialize. Always power the transmitter ON before the
vehicle and power it OFF after the vehicle has been powered OFF.
6. Check the steering and throttle control directions. Verify that the
servos are moving in the correct direction.
7. Drive your vehicle.
8. Perform any necessary maintenance.
VEHICLE PREPARATIONS
CHARGING THE VEHICLE BATTERY
NOTICE:
Never charge a battery in the vehicle or damage may result.
1.
Connect the AC power cord to the power slot on the charger, then
connect the other end of the power cord to an AC power source.
2.
The three LEDs will turn GREEN when the charger is connected to
the AC power source.
3.
Connect the balance connector of the battery pack to the proper
connector on the charger (the 3S connector has 4 pins and the 2S
connector has 3 pins).
4.
The three LEDs will turn RED, indicating the battery is charging.
5.
When the charging of one cell is complete, the corresponding LED
turns GREEN.
6.
Once the battery pack is fully charged, all three LEDs will turn
GREEN.
7.
Disconnect the balance connector and battery from the charger.
NOTICE:
Only charge the included Li-Po battery with the included
Li-Po charger.
CHARGING WARNINGS
CAUTION:
All instructions and warnings must be followed
exactly. Mishandling of Li-Po batteries can result in a fire,
personal injury and/or property damage.
• NEVER LEAVE CHARGING BATTERIES UNATTENDED.
• NEVER CHARGE BATTERIES OVERNIGHT.
• By handling, charging or using the included Li-Po battery, you assume all
risks associated with lithium batteries.
• If at any time the battery begins to balloon or swell, discontinue use
immediately. If charging or discharging, discontinue and disconnect.
Continuing to use, charge or discharge a battery that is ballooning or
swelling can result in fire.
• Always store the battery at room temperature in a dry area for best
results.
• Always transport or temporarily store the battery in a temperature range
of 40–120º F (5–49° C). Do not store battery or model in a car or direct
sunlight. If stored in a hot car, the battery can be damaged or even catch
fire.
• Always charge batteries away from flammable materials.
• Always inspect the battery before charging.
• Always disconnect the battery after charging, and let the charger cool
between charges.
• Always constantly monitor the temperature of the battery pack while
charging.
• ONLY USE A CHARGER SPECIFICALLY DESIGNED TO CHARGE LI-PO
BATTERIES. Failure to charge the battery with a compatible charger may
cause a fire resulting in personal injury and/or property damage.
• Never discharge Li-Po cells to below 3V under load.
• Never cover warning labels with hook and loop strips.
• Never leave charging batteries unattended.
• Never charge batteries outside recommended levels.
• Never charge damaged batteries.
• Never attempt to dismantle or alter the charger.
• Never allow minors to charge battery packs.
• Never charge batteries in extremely hot or cold places (recommended
between 40–120° F or 5–49° C) or place in direct sunlight.
