6
EN
™
changIng the traVel adjust settIngs
transMItter controls
Battery leVel
IndIcator
Solid Green: Battery
voltage is good (above
4V).
Flashing Green: Battery
voltage is critically low
(below 4V). Replace
batteries.
throttle trIM
Adjusts the neutral point
of the electronic speed
control.
steerIng trIM
Adjust to make the vehicle
drive straight with no input
at the steering wheel.
PoWer sWItch
Power on
or off the
transmitter.
steerIng Wheel
Control steering. Right and
Left steering with ST. REV
Switch on N
(see ST. REV switch).
throttle trIgger
Controls power to motor for forward
or reverse (see TH. REV switch).
Stop
Reverse
(when TH.
REV switch
on N).
Forward
(when TH.
REV switch on N).
steerIng rate
Adjusts the amount the
front wheels move when the
steering wheel is turned left
or right.
reVerse sWItch
Allows you to change the
direction of steering (ST. REV)
and throttle (TH. REV) controls
(default settings are “N” for
steering and “N” for throttle).
The travel function supports precise endpoint adjustments in
each direction for the steering and throttle channels.
1. Hold the trigger in the full brake position while powering
on the transmitter. The LED flashes rapidly, indicating the
programming mode is active.
2. Throttle End Point: Hold the trigger in the full throttle position.
Turn the TH TRIM knob to adjust the full throttle end point.
3. Brake End Point: Hold the trigger in the full brake position.
Turn the TH TRIM knob to adjust the full brake end point.
Return the trigger to the center position.
4. Left Steering End Point: Hold the steering wheel in the full left
position. Turn the ST TRIM knob to adjust the left end point.
5. Right Steering End Point: Hold the steering wheel in the full
right position. Turn the ST TRIM knob to adjust the right end
point. Return the steering wheel to the center position.
6. Power off the transmitter to save the travel adjust settings.
The minimum Travel is 75%, and the Maximum travel is
150%. The default travel settings are 125% steering and
100% throttle.
