ECTACO Partner
®
P850
User Manual
9
LED status: blinking blue – recording is in progress or data being transferred; blinking
red – SD card is being scanned, or the battery is critically low.
Note:
Charge the battery overnight prior to the first use of the device.
SD Card
Before you start using your ECTACO Partner
®
P850, please make sure the SD card
(included in the standard package) is installed into the
SD slot
of the device. If the card is
not installed, slide it into the slot located on the right-hand edge of the device – the
contacts of the card face up, label face down. Push the card gently until it clicks into
place. To eject the card, just push it in slightly.
Initialization
In the rare event that the data on the screen is corrupted or a program is not responding
properly, you will need to perform a reset.
The
Reset
button is located on the left-hand side of the keyboard (over the
key). It
can be accessed with any thin object like a paper clip. Never use a needle or a sharp pin
for this purpose since it can damage the device.
•
Unscrew the removable cap of the stylus – it will serve you as a reset pin.
•
Press the
Reset
button.
On completion of the reboot, you will see the calibration screen with five targets,
appearing one after another as you tap them with the stylus. Tap the screen to accept the
new calibration settings.
Keyboard
The American standard QWERTY keyboard allows you to enter any word just in seconds.
Each set of national characters is linked to its language input mode.
The function and control keys are described below.
Note:
Key1+Key2 here and further on signifies the combination of keys to use – first
press and hold Key1, then press and release Key2.
Key Function(s)
Turn the device on or off
Reset Re-initialize
system
Use speech recognition (available in
Audio PhraseBook
)
Show or hide the pop-up toolbar
