19
When you first start up your system, go immediately to the Setup Utility to
configure the floppy diskette drives that you have installed. See Standard
CMOS Features on page 28 for more info rmation.
Installing Add-on Cards
This mainboard has six 32-bit PCI (Peripheral Components Interconnect)
expansion slots, one 4xAGP slot, and one Communications and Networking
Riser (CNR) slot.
PCI Slots
PCI slots are use to install expansion cards that have the 32-bit
PCI interface.
Note:
When VT6202 USB 2.0 is present on the mainboard,
the PCI 6 will be automatically set to Slave PCI.
4xAGP Slot
The 4xAGP slot is used to install a graphics adapter that supports
the 4xAGP specification and has a 4xAGP edge connector. The 4x
AGP slot supports 1.5V 4x AGP and 2x AGP cards only.
Note:
The above layout is for reference only. The AGP slot
may be different from your mainboard. Please refer to
actual shipment.
CNR Slot
This slot is use to insert CNR cards with Modem and Audio func-
tionality.
Note:
Before installing an add-on card, check the documentation for the card
carefully. If the card is not Plug and Play, you may have to manually con-
figure the card before installation.