ECS CDC-I, Руководство пользователя

Страница: 19 / 56

15
Installing the Motherboard
F_USB1~2: Front Panel USB headers
The motherboard has four USB ports installed on the rear edge I/O port array.
Additionally, some computer cases have USB ports at the front of the case. If you
have this kind of case, use auxiliary USB connector to connect the front-mounted
ports to the motherboard.
1
USBPWR Front Panel USB Power
2
USBPWR Front Panel USB Power
3
USB_FP_P0- USB Port 0 Negative Signal
4
USB_FP_P1- USB Port 1 Negative Signal
5
US USB Port 0 Positive Signal
6
US USB Port 1 Positive Signal
7
GND Ground
8
GND Ground
9
Key No pin
10
RSVD Reserved
Pin Signal Name Function
Please make sure that the USB cable has the same pin assignment as
indicated above. A different pin assignment may cause damage or system
hang-up.
SATA1~2: Serial ATA connectors
These connectors are used to support the new Serial ATA devices for the highest data
transfer rates (3.0 Gb/s), simpler disk drive cabling and easier PC assembly. It elimi-
nates limitations of the current Parallel ATA interface. But maintains register com-
patibility and software compatibility with Parallel ATA.
1
Ground
2
TX+
3
TX-
4
Ground
5
RX-
6
RX+
7
Ground
-
-
Pin Signal Name Pin Signal Name
CASE: Chassis intrusion detect header
This detects if the chassis cover has been removed. This function needs a chassis
equipped with instrusion detection switch and needs to be enabled in BIOS.
Short
Chassis cover is removed
Open
Chassis cover is closed
Pin1~2 Function