ECS AMD690GM-M2, Руководство пользователя, Страница: 30 / 68

24
Installing the Motherboard
SATA1~4: Serial ATA connectors
These connectors are used to support the new Serial ATA devices for the highest date
transfer rates (3.0 Gb/s), simpler disk drive cabling and easier PC assembly. It elimi-
nates limitations of the current Parallel ATA interface. But maintains register com-
patibility and software compatibility with Parallel ATA.
1
Ground
2
TX+
3
TX-
4
Ground
5
RX-
6
RX+
7
Ground
-
-
Pin Signal Name
Pin Signal Name
TV_OUT1: TV-out header
Users may connect this header to your TV set to achieve the TV-out function.
SPDIFO: SPDIF out header
This is an optional header that provides an S/PDIF (Sony/Philips Digital Interface)
output to digital multimedia device through optical fiber or coxial connector.
1 SPDIF SPDIF digital output
2 VCC +5V power
3 Key No pin
4 GND Ground
Pin Signal Name
Function
WOL1: Wake On LAN connector (Optional)
If you have installed a LAN card, use the cable provided with the card to plug into the
WOL1 connector onboard. This enables the Wake On LAN (WOL) feature. When
your system is in a power-saving mode, any LAN signal automatically resumes the
system. You must enable this item using the Power Management page of the Setup
Utility in the BIOS. See Chapter 3 for more information.
1
5VSB +5V stand by power
2
GND Ground
3
Wake_up Wake up signal (low active)
Pin Signal Name Function
Pin Signal Name Function
1
GND Ground
2
COMP Composite
3
LUM Luminance
4
GND Ground
5 CHROMA
Chrominance
6
KEY No pin