ECS Electronics TO-245-HHU, Руководство пользователя

Страница: 13 / 14

© ECS Electronics B.V. Pag. 13 TO-245-HHU / 190417CD
Option!
P
Info
?
P.D.C.
P.D.C.
PARK DISTANCE CONTROL
PARK DISTANCE CONTROL
Option 1
Option 2
AUTO PARK-SENSOR SWITCH-OFF FUNCTION WITH
THE 5D033 ECU
FUNCTION
INFO
P.D.C.
PDC
Manual
L Locate the PDC (Parking Sensor) Module in the Vehicle.
OPTION 1 When the PDC-system has no specific MUTE wire: Locate and cut the wire at ONE of the locations A-G and connect to the ECS
Towbar Wiring Kit as shown in Option 1. Always check if cutting the wire at the selected location does not create any errors
in the PDC-system or the vehicle, if so, then select another location. In this case the cut wire is connected and the system
operates normally. When the trailer is connected. This wire becomes disconnected by the Trailer Module. If the same module
also controls the Front Sensors then use only locations F or G to prevent the front sensors switching off.
OPTION 2 When the PDC-system has a specific MUTE wire: Check in the manual of the PDC-sysctem which input the PDC module requires
to switch off the system (+12v or Earth trigger). Then connect the Trigger wire of the PDC system to pin 9 of the ECS connector,
and connect the required feed (+12v or Earth) to pin 7 and 5.
Be careful as connecting the wrong feed can cause damage to the PDC-system.
Always check Before and After installation the PDC System is working correctly, and where possible any error codes
9
5
7
5
7
1 3 5
2 4
R
=
9
5 3 1 7 9
Lorem ipsum