ECRM Mako 8 CTP, Руководство оператора, Страница: 39 / 56

AG114123 Rev. 2 33
Installing a Pin Bar
Step 1. .Pull and hold open the pin bar
release lever shown at the right.
This opens the retaining block
shown below in Figure 3-5.
Step 2. If necessary, remove the old pin bar.
Step 3. Position the new pin bar above the
pin bar mount assembly so that:
• the interlock pin is just ahead of
the stud shown in Figure 3-5.
• the back end of the pin bar lines up with the pin bar release
lever.
Step 4. Push down on the pin bar down to snap it in place in the pin bar
mount assembly.
Figure 3-5 Pin Bar Mount Assembly (with Release Lever Open)
Step 5. Release your hold on the pin bar release lever.
CLOSED
OPEN
Figure 3-4
STUD
RETAINING
BLOCK